Related part should be operated under low voltage condition. All installation process and maintaince be carried out by the supplier.
Name of Related Parts
▪JST connection( Red:24V power cable; Yellow: Relay )
▪COM / NO
▪The indicator will shin for few seconds when starting. When object is detected by sensor, indicator lights up.
▪Fluctuation up and down, rotation left and right.
1.Please do the installation in the proper position, installation height within 3.5m. Please arrange hole (Φ3.2mm) on the installation module. And hole (Φ12m) for insetting guide line.
2.Please connect the signal cable with the terminal of automatic door.
3.Take the outer cover off, and fix the screws.
4.Finish the cable connection and get on power.
5.Please set the detection range and disjunctor accordingly.
6.Cover with the lid.
Picture of Automatic Glass Door Microwave Motion Sensors
▪Position should be fixed tightly to avoid virbrating.
▪Do not place into board or other material.
▪Moving object should be avoided.
▪Fluorescent should be avoided.
▪Do not touch directly, ESD protection is necessary.
|Door&indicator lose failure||Did not get power||Check cable connection&power supply|
|Door keep on closed and open||Sensor detected the movement of autodoor, vibration of movement||1.Adjust angle|
2.Check the position
|Door do not close Red indicator lose failure||1.Switch of autodoor controller lose failure|
3.Incorrect output sensor
|Check the switch of autodoor controller &setting of output|
|Door keeps on moving when it rains||Sensor detected the actins of rain||Adopt waterproof accessories|
Technology:Microwaveµwave disposer Frequency:2.4GHz
Transmitting power: 20dBm EIRP Launch
Frequency density: 5mW/cm2
Installation Angle:0-90 degree(lengthways) -30 to +30(lateral)
Detection Mode:Moving Min detection speed:5cm/s
Detection range:8m*4m(Installation Height 2.2M) Maximum voltage:42AC-60V DC Maximum Current:1A
Maximum switching power:30W(DC)/60VA(AC)
Retention time:0.5S Guide line:2.5M
Anti-interference performance:R&TTE 1995/5/EC,EMC 89/366/EEC
Power Voltage 12V to 36V DC
Other Automatic Doors Accessories
The automatic door operator is to be fully electronic operator, housed in a fully anodised aluminum transom section.
The intelliget controller unit can be programmed for connection to any security/alarm systems, is self monitoring and calibrating, has memory for all data on door stoke and brake positions.
The operator has built-in uninterrupted power supply (Battery back up) operation and security during power failure.
Drive is by way of toothed belt, which is reinforced with fiberglass tensile members, and has nylon facing surface for tooth protection on the pulleys. This combination produces silent accurate operation.
The track is self-cleaning duel linear. The upper track is made of harder stronger alloy 6351T6, and can be replaced without moving the transom. The wheel trolley is fitted with anti-rise wheels, resulting in very firmly fitted doors with operation free of any racking.
Electromechanical Locking: An electric lock option is available to give total security and can be adapted where manual locking cannot be achieved, i. E. Frameless toughened Glass doors. Lock is the microprocessor controlled electric locking system. The microprocessor monitors all aspects of the lock functions. E. G. To ensure the door is fully closed when the lock is 100% engaged. Terminal outputs are available to signal to security system both door positions and lock status.